lajar.blogg.se - Macbook pro user guide 2015 pdf

You can add the rotary attachment to engrave cylindrical items. Note: Before using the cable ties, reserve a sufficient cable length to allow the laser head to slide between the left and proper plates.

Use cable ties to fix the cables on the middle plate.

Insert the laser head along the guide rail, and then lock it in a required position by using the thumbscrew on the side. Stick the cable into the slot of the fan baffle, and then insert the connector into the port.

Connect the laser head to the main control board.

Use cable ties to fix the cables on the plate.

Connect the motor on the middle plate to the main control board.

Insert the motor & laser cables into the ports on the main control board.

Note: Use cable ties to fit the cable on the plate so that the cable doesn't interfere with the operation of xTool D1. Note: Press the connectors of the motor cable into place to prevent poor contact.

Use the motor cable to connect the motor on the left plate to the main control board.

(2) Put the timing pulley through the timing belt, and then tighten the screws on the coupling. (1) Drag the middle plate to make it close to the rear plate.

Use the screw to set the tightness of the timing belt on the middle plate.

Otherwise, the material can't carve adequately.

Make sure that you set the timing belts on the left and proper plates with the same tightness.

Otherwise, the timing belts may be damaged. Do not fully tighten the most extended extension.

The purpose of the most extended extension screw is to set the tension of the timing belt.

Use screws to set the tightness of the timing belts on the left and proper plates.

Before you pull the screws, press each joint of the plates to ensure no support hangs in the air.

Align a screw with the screw hole before tightening it.

Tighten screws at each joint of the plates to fix them together.

Fit the four side plates together on a desk or flat ground.

Cut off the cable tie on the right plate.